Detex V40 EE User Manual download pdf (Page 6)

MORTISE CYLINDER INSTALLATION

CHECKING FOR DEVICE CLEARANCE

Electrified Model

(Cut-Off procedure if required)

door frame clearance.

proceed to MORTISE

If no cut-off needed,

Secure with tape

Check device and

CAUTION:

onto extrusion

Slide endcap assembly

Cut fillerplate

desired length

and extrusion to

Protect wires

during cutting

Type

Max Cut-Off

36" Unit

Length (L)

48" Unit

6 in

PRECAUTIONARY NOTE:

cannot be

cut down

CYLINDER INSTALLATION

Do not overtighten

NOTE:

CAUTION:

Tighten with hand tools only.

1. See "EE ELECTRICAL OPTIONS" before reinstalling filler plate.

2. Be careful when installing fillerplate assembly not to damage wires.

View A

Modular Cable

Connection

View B

12 Pin Connection

(note: board layout may differ slightly from layout shown)

View C

2 Pin Connector

See View A, B, & C above

Remove endcap, endcap bracket & fillerplate subassembly.

Disconnect cable assembly (view A),

12 pin connector (view B), 2 pin connector (view C)

and battery

Re-connect in the following order:

1) Cable assembly (view A),

2) Battery,

3) 12 pin connector (view B),

4) 2 pin connector (view C).

Install fillerplate subassembly

& endcap bracket.

Install mortise cylinder

with hex nut provided

INSTALLING MORTISE CYLINDER

Dogging lever should be in "ON"

(CCW) position before sliding back

into extrusion

Use optional cylinder collar

(Detex p/n: ECL-1595)

when

installing 7-pin mortise cylinder

(1) Move placement of

spacers to match length

of cylinder used to allow

smooth rotation of cam.

2) All cylinder spacers

must be used, either

on top or bottom

RE-INSTALL FILLERPLATE

103185 Page 6

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

Detex V40 EE User Manual Page 6

Comments to this Manuals

Related products and manuals for Safety Detex V40 EE